Rubber Grommets

Grommets are generally flared or collared on each side to keep them in place, and made in various polymers depending on the application. They may be used to prevent tearing or abrasion of the pierced material or protection from abrasion of the insulation on the wire, cable, line being routed through the penetration, and to cover sharp edges of the piercing, or all of the above. These are also use in Irrigational sector for Drip Irrigation. We are also one of the largest Suppliers of Drip Irrigation Rubber Grommets.

Most common are molded rubber that are inserted into small hole diameters up to 2" in diameter. There are many hole configurations from standard round to assorted U-shapes. Larger penetrations that are irregular in shape as well as long straight edges often use extruded or stamped strips of continuous length. These Continuous length materials are referred to as "grommet edging".

These are quite common in applications that range from telecom switches and data center cabinets to complex and dense wire/cable and even hydraulic tubing in aircraft, transportation vehicles and medical equipment.

Grommets are also manufactured from over 15 polymers including:  Nitrile / Buna-N (NBR), Fluorocarbon (Viton®, Fluorocarbon (FKM), Silicone (VMQ), Fluorosilicone (FVMQ), Polyurethane (AU/EU), Natural Rubber (NR), Ethylene Propylene (EPDM), Hydrogenated Nitrile Rubber (HNBR), Styrene Butadiene Rubber (SBR), Chloroprene (Neoprene®), etc